iCloud Bypass with Arduino for A5/A5X
A5 and A5X checkm8 is finally possible, thanks to AppleTech752 @a1exdandy and @synackuk! In this tutorial made by AppleTech752, we will show how to properly set up the hardware and software components necessary to execute the new A5 checkm8 exploit.
This is a very good method for mobile shops repair to bypass older iphones and ipads usinf A5 ships.
The method shown in this video is 100% UNTETHERED, so you can reboot/power off without any issues. No need to restore the device first!
With the Arduino Uno and USB Host Shield, you can connect your A5 device (iPod Touch 5, iPad Mini 1, iPhone 4s, iPad 3 or iPad 2) and enter PWNED DFU MODE. This is equivalent to the ./ipwndfu -p command that many of you probably know very well.
- Ipad mini 1 Cellular iOS 9.3.6
- ipad 2 iOS 9.3.5
- ipad 3 iOS 9.3.5
- ipad 4 cellular iOS 10.3.3
- iphone 4S
Where u can Buy Arduino Uno Rev3 SMD
The Arduino Uno is a microcontroller board based on the ATmega328. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started
Make sure you installed the @synackuk build of checkm8-a5 on your arduino (not a1exdandy). Then you can use the iBSS ONLY option on Sliver 5.4 to verify that iBSS loads correctly. If you get “done!” in the popup, reboot+re-pwn and try Standard
Sliver works on MacOS High Sierra or Mojave, NOT Catalina. If you have Catalina you can install a second partition without downgrading. If you have an old mac, there are ways to force update to high sierra.